MULTIDEC®-TAPER-IN

multidec^®-TAPER-IN is a tool holder serie that has been specially developed to be used on Swiss type turning machines. These tool holders have a monoblock design in order to achieve the highest possible stability. The multidec^®-TAPER-IN tool holders can be used in any driven or stationary spindle compliant with the DIN 6499 standard.

1  Precision-ground drill hole for maximum end mill concentricity

2  Clamping screws

3  Snap-fit surface

4  DIN 6499-compliant ground taper

5  Positionable stop

1  Precision-ground installation surface for maximum concentricity and true-running characteristics of the saw blades and side mills

2  Snap-fit surface

3  DIN 6499-compliant ground taper

Benefits:

• Ideally suited to Swiss-type turning machines (profile turning)

• Direct fit in the collet chuck with ER cone

• No special clamping nuts are needed

• Monoblock design for reduced added tolerance

• High stability

• Ground surfaces

• Holder for ER sizes 8, 11, 16, 20 and 25

• Concentric accuracy of 0.005 mm

• Stop screw adjustable on both sides for tool positioning