MULTIDEC®-taper-in

multidec®-TAPER-IN is a toolholder programme that has been specially developed for use on sliding headstock lathes. These toolholders are designed as a monoblock so that the highest possible stability can be achieved. The multidec®-TAPER-IN toolholders can be used in any driven or stationary spindle according to DIN 6499.

Advantages:

  • Ideally suited for sliding headstock lathes (Swiss type machining)

  • Fits directly into the collet holder with ER taper

  • No special clamping nut is necessary

  • Monobloc for reduced tolerance addition

  • High stability

  • Polished surfaces

  • Holder for ER sizes 8, 11, 16, 20 and 25

  • Concentricity 0.005 mm

  • Adjustable stop screw on both sides for tool positioning